Study of the Effect of 3-D Spacer Fabric on Flexural and Tensile Strengths of Concrete Roll

Document Type : Research Paper

Authors

1 Researcher of Imam Hossein University, Faculty of Engineering and Passive Defense

2 Imam Hosein Uni

3 imam Hosein Uni

4 rasht university

10.22124/jcr.2024.22525.1587

Abstract

Nowadays, concrete roll is used in various fields of civil engineering and architecture. Therefore, improving the mechanical properties of this product is important in order to increase the scope of its using. In this study, the effect of yarn and weave of 3-D spacer fabric was investigated on flexural and tensile strengths of concrete roll. For this purpose, four samples of 3-D spacer fabrics with different yarns and weaves were prepared and the cement was injected into these samples. After hydration of concrete roll, the initial cracking stress, final stress and tensile strength were obtained. The results showed that the number of spacer yarns has a significant effect on the amount of initial cracking stress, and the final stress of flexural strength is also increased almost with increasing the initial cracking stress. The results also showed that the type of yarn used in the 3-D spacer fabric has a significant effect on the tensile strength. The tensile strength of concrete roll is increased with increasing the capillary ability of the samples, due to the better hydration of concrete.

Keywords

Main Subjects

References

[1] Jongvivatsakul, P., Ramdit, T., Ngo, T., and Likitlersuang, S. (2018) "Experimental investigation on mechanical properties of geosynthetic cementitious composite mat (GCCM) ", Construction and Building Materials, Vol. 166, pp. 956-965.
[2] Jun, Z., Wei, X., Xingzhong, W., Peiwei, G., Zhihua, Y., Lihai, S. and Jiang, W. (2020) "Application and research status of concrete canvas and its application prospect in emergency engineering", Journal of Engineered Fibers and Fabrics, Vol. 15, pp. 1-11.
[3] Pandey, R. and Jegatheeswaran, D. (2019) "Concrete Canvas: Solution of Pavement", Journal of Mechanical and Civil Engineering, Vol. 16, pp. 19-21.
[4] Lakshmi Prasanna, C., Amar Deepak, B. and Tech, M. (2019) "Concrete Canvas: A Multifaceted Construction Material", International Journal of Recent Technology and Engineering, Vol. 8, pp. 1898- 1901.
[5] Li, H., Chen, H., Liu, L., Zhang, F., Han, F., Lv, T., Zhang, W. and Yang, Y. (2016) "Application design of concrete canvas (CC) in soil reinforced structure" , Geotextiles and Geomembranes, Vol. 44, pp. 557-567.
]6[ فیاض، م.، قربان نژاد، ع.، خسروی، ف. (1398) "مطالعه عددی خسارت های وارد بر پوسته ساخته شده از بتن پارچه ای تحت تاثیر انفجار نزدیک"، علوم و فناوری پدافند نوین، دوره 10، صفحه 79-87.
[7] Armakan, D.M. and Roye, A. (2009) "A study on the compression behavior of spacer fabrics designed for concrete applications", Fibers and Polymers, Vol. 10, pp. 116-123.
[8] Ma, P., Jiang, G. and Gao, Z. (2017), ''The three dimensional textile structures for composites'', In Advanced Composite Materials: Properties and Applications. De Gruyter Open Poland. pp. 497-526.
[9] Roye, A. and Gries, T. (2007) "3-D textiles for advanced cement based matrix reinforcement", Journal of Industrial Textiles, Vol. 37, pp. 163-173.
[10] Peled, A., Cohen, Z., Pasder, Y., Roye, A. and Gries, T. (2008) "Influences of textile characteristics on the tensile properties of warp knitted cement based composites", Cement and Concrete Composites, Vol. 30, pp. 174-183.
[11] Yip, J. and Ng, S-P. (2008) "Study of three-dimensional spacer fabrics: Physical and mechanical properties", Journal of Materials Processing Technology, Vol. 206, pp. 359-364.
[12] Han, F., Chen, H., Jiang, K., Zhang, W., Lv, T. and Yang, Y. (2014) "Influences of geometric patterns of 3D spacer fabric on tensile behavior of concrete canvas", Construction and Building Materials, Vol. 65, pp. 620-629.
[13] Du, G-W. and Ko, F. (1996) "Analysis of multiaxial warp-knit preforms for composite reinforcement", Composites Science and Technology, Vol. 56, pp. 253-260.
[14] Hu, J., Jiang, Y. and Ko, F. (1998) "Modeling uniaxial tensile properties of multiaxial warp knitted fabrics", Textile Research Journal, Vol. 68, pp. 828-834.
[15] Jiang, Y., Hu, J. and Ko, F. (1999) "Characterizing and modeling bending properties of multiaxial warp knitted fabrics", Textile Research Journal, Vol. 69, pp. 691-697.
[16] Khondker, O., Leong, K., Herszberg, I. and Hamada, H. (2005) "Impact and compression-after-impact performance of weft-knitted glass textile composites", Composites Part A: Applied Science and Manufacturing, Vol. 36, pp. 638-648.
[17] Toledo Filho, R.D., Ghavami, K., Sanjuán, M.A. and England, G.L. (2005) "Free, restrained and drying shrinkage of cement mortar composites reinforced with vegetable fibres", Cement and Concrete Composites, Vol. 27, pp. 537-546.
[18] Han, F., Chen, H., Zhang, W., Lv, T. and Yang, Y. (2016) "Influence of 3D spacer fabric on drying shrinkage of concrete canvas", Journal of Industrial Textiles, Vol. 45, pp. 1457-1476.
[19] Abdellahi, S.B., Hejazi, S.M. and Hasani, H. (2018) "Investigation of flexural behavior of 3D textile reinforced concrete using both experimental tests and finite element method", Journal of Sandwich Structures & Materials, Vol. 20, pp. 578-594.
]20[ امیری، ه.، فیاض، م.، رعیا، ا. (1401) "ارزیابی عملکرد بتن پارچه‌یی در پناهگاه تعجیلی"، مهندسی عمران، دوره 38.2، صفحه 15-25.
[21] Hajipour, A. and Shams Nateri, A. (2019) "The effect of weave structure on the quality of inkjet polyester printing", The Journal of the Textile Institute, Vol. 110, pp. 799-806.
[22] Hajipour, A. and Shams-Nateri, A. (2017) "The effect of fabric density on the quality of digital printing on polyester", Fibers And Polymers, Vol. 18, pp. 2462-2468.
[23] Chatterjee, A. and Singh, P. (2014) "Studies on wicking behaviour of polyester fabric", Journal of Textiles, Vol. 2014, pp. 1-11.
[24] Saricam, C. and Kalaoğlu, F. (2014) "Investigation of the wicking and drying behaviour of polyester woven fabrics", Fibres & Textiles in Eastern Europe, Vol 22, pp. 73-78.
[25] Sampath, M., Mani, S. and Nalankilli, G. (2011) "Effect of filament fineness on comfort characteristics of moisture management finished polyester knitted fabrics", Journal of Industrial Textiles, Vol. 41, pp. 160-173.
 

Files

Share

How to cite

Statistics