Effect of High Performance Fiber Reinforced Cementitious Composites (HPFRCC) and Transverse Reinforcement on the plastic Hinge Characteristics and Moment Redistribution in Continuous Concrete Beams

Document Type : Research Paper

Authors

1 Faculty of Engineering, Islamic Azad University, Semnan, Iran

2 Civil Eng. Faculty, Semnan University

10.22124/jcr.2022.15837.1426

Abstract

In this paper, the results of Experimental Investigation Determination the Moment Redistribution and Plastic Hinge in continuous concrete Beams by replacing normal Concrete with HPFRCC and reducing the spacing of the stirrups are presented. Eight specimens of beam with reinforced concrete and fiber reinforced cement composites with bending distance were considered as three groups of A, B and C. Group A consisted of two conventional bending beams with standard bending intervals (d/2) (reference sample) and compact (d/4). Group B consists of four beams made of reinforced cement composites reinforced as a layer with non-compressive bending intervals (d/2) and Group C comprises two beams made of reinforced cement composites. Strong fibers were fully compressed (d/2) and compressed (d/4). Experimental results showed that using reinforced cement composite reinforced fibers instead of normal concrete in different parts of beams and the use of compacted stirrups increased the ductility of beams. In the specimens made of HPFRCC with compressive stirrups, bearing capacity, displacement ductility and energy ductility increased by 35, 77 and 83%, respectively, compared to the reference sample. The highest amount of moment redistribution, occurred in the specimen made with HPFRCC in the lower part with 1.51 times the reference beam.

Keywords

Main Subjects


[1] Ghods, A., Sharbatdar, M.K., (2020). “An investigation on the behavior of two fixed end beams cast with HPFRCC composite”, Case Stud. Constr. Mater. 13 (2020) e00466.
 [2]Do Carmo, R. N., & Lopes, S. M., 2008. Available plastic rotation in continuous high strength concrete beams. Canadian Journal of Civil Engineering, 35(10), 1152-1162.
[3]Farahbod, F., & Mostofinejad, D., 2011. Experimental study of moment redistribution in RC frames strengthened with CFRP sheets. Composite Structures, 93(3), pp. 1168-1177.
 [5] Mousavi Esfahani, S.V.,  Sharbatdar, M.K., (2020). “Substitution effects of conventional concrete with high-performance fiber-reinforced cementitious composite (HPFRCC) in beams reinforced with GFRP bars”, Case Stud. Constr. Mater. 13 (2020) e00440.
 [6] Visintin, P. Ali, M. A. Xie, T. Sturm, A. B. Experimental Investigation of Moment Redistribution in Ultra High Performance Fiber Reinforced Concrete Beams, Construction and Building Materials, 2018. 166, p: 433-444
[7] Lin,C.H and Chien, Y.M. (2000). “Effect of Section Ductility 0n Moment redistribution of Continuous Concrete Beams”.journal of the Chinese institute of engineering,23(2)131-141
[8] Lopes,S.M.R.and Bernando, L.F.A.(2003).”Plastic rotation capacity of high strength concrete beams.”jornal of materials and structures,36(1),23-31
[9] Naaman,A.E. and Reinhardt,H.W.2003.”Setting the stage: toward performance – based classification of FRC composites “.in high performance fiber reinforced cement composites, proc. of the 4th int 1 RILEM workshop, A.E. Naaman and H.W. Reinhardt.
 [10] Hemmati, A., Kheyroddin, A, Sharbatdar, M.K, Increasing the flexural capacity of RC beams using partially HPFRCC layers. Computers and Concrete, Vol. 16, No. 4 (2015) 545-568
 [11] Hemmati, A., A. Kheyroddin, and M.K. Sharbatdar, Plastic hinge rotation capacity of reinforced HPFRCC beams. Journal of Structural Engineering, 2013. 141(2): p. 04014111.
 [12] ACI 318-14, 2014. Building code requirements for structural concrete and commentary, Michigan (USA), American Concrete Institute
 [13] Committee, J.C., Recommendations for design and construction of high performance fiber reinforced cement composites with multiple fine cracks. Japan Society of Civil Engineers, Tokyo, Japan, 2008
[14] Kheyroddin, A., (1996)."Non linear Finite Element Analysis of Flexure-Dominant Reinforced Concrete Structures", Ph.D. Thesis, Department of Civil Engineering and Applied Mechanics, McGill University, Montreal, Canada, 290p